Peak Flow - EN 23747

EN 23747 Standard has now been harmonised by ISO 23747 Standard. Website to be updated shortly.

New Peak   Expiratory Flow Standard



How will the change affect me as a:

Pharmacist/Wholesale Section

What difference does it make to me as a Pharmacist?

Pharmacists may already be aware of impending change, as from June 2004 the NHS Drug Tariff has reported that Wright-scale meters presently available for reimbursement would be deleted from September 1st 2004 to be replaced by meters that conform to the EN 23747 standard (the EU scale).

Pharmacists will need to be aware of both clinical implications, and how to minimise supply problems. Clement Clarke have taken advice from various professionals, including the PSNC, the NPRC, the NPA and major wholesalers, and hope the detail on these pages will address most of the issues affecting Pharmacists and their patients.

What is the difference between the two scales?

PEF readings obtained on an EU scale meter will be more accurate than those from a Wright scale meter, because changes in airflow will result in PEF readings changing uniformly for the whole range of the meter. The Wright scale has been previously noted to over-represent changes in airflow in the mid-range, and under represent changes in the low and high ranges.

Correcting these small inaccuracies produces PEF readings that are different - until the new EN 23747 Standard meters are used for all PEF measurements, it will be important to note which scale has been used to used with the patient.

How will the changes affect my patients?

Those patients using peak flow meters can be divided into two groups:

1)New patients - using a meter for the first time

2)Existing patients - already using a peak flow meter

Patients using a peak flow meter for the first time in 2004 will soon all be given the new EU scale meter, and be ignorant of the change from the Wright scale. However, existing asthmatic patients who require a replacement meter will notice that the meter and their readings will have changed, and without explanation from a knowledgeable healthcare professional, may be worried that their health has deteriorated, or the meters being used were, or are faulty.

Importantly, professionals caring for patients who use peak flow meters will need to note which type of meter has been used to take measurements - it is unlikely that all patients will have their old meters replaced immediately, the result being that both Wright and EU scale meters will be in common use for several years after the introduction of the EN 23747 Standard in 2004.

Will I be able to obtain the new peak flow meters before 1st September 2004?

Yes. Clement Clarke will make the new EU-scaled meters available during July and August, but will maintain a supply of Wright-scale meters until the end of August 2004, to ensure NHS prescriptions can be dispensed AND reimbursed. See below for PIP codes and part numbers.

What difference will I see in the peak flow meters I supply patients?

The new peak flow meters will have a similar appearance to the old meters, but the scale (the part of the meter that you read the PEF value from) will have changed.

If you have a Mini-Wright, the EU scale will be a different colour - blue text printed on a yellow background. Apart from the scale, the new Mini-Wright will behave and handle as reliably as the old meter.

The Mini Wright Standard Range Peak Flow Meter, showing the scale and pointer of old and new versions

If you are not sure which peak flow meter you have, Click here to contact us

How can I tell what type of meter I have?

1. Look at the meter and its instruction leaflet. There should be a description of the meter and who manufactured it.

2. Check its features against the information on Mini-Wright on display here (Click here to check)

3. Check the product PIP code against the table below, or if you do not have a Mini-Wright, then ask your supplier.

Note. The EN 23747 Standard requires that the meter itself carry full details of the type of meter, and the company who manufactured it. Meters that do not have this detail are not compliant with the new Standard, and therefore may not be able to monitor lung function accurately.

Are there any other differences between the two types of scale?

Yes - the new EN 23747 Standard sets minimum acceptable levels for the overall performance of peak flow meters, for such criteria as repeatability, accuracy, airflow resistance and reliability. Some manufacturers will have to modify their existing designs of peak flow meter to ensure they comply with the new standard - the poor accuracy of some meters may result in them being withdrawn from the market.

How should I note the different PEF readings?

It would be sensible to record all PEF readings with a description of which scale: e.g.

550 EU or 574 Wright

Ideally, patients and health professionals should all have the same scale meter, but this may take several years to achieve. Patients should have their old meter replaced at the earliest opportunity, and certainly before September 2005. If PEF readings have been taken using a Mini-Wright, it is possible to convert from one scale to the other, where required. (Click here to convert PEF readings)

Is it true that the Nunn and Gregg predictive values are no longer valid?

This is not entirely true.

The PEF normal values offered by the Nunn and Gregg analysis remain a highly regarded source of predictive values, but the readings they reported were from peak flow meters calibrated to the Wright scale.

Without conversion to the equivalent reading on an EU scale meter, they are misleading. However, it is possible to convert them, using the formulae developed by Clement Clarke.

Are there predictive values for the EU Scale PEF meter?

Some data sets are available, but as yet there is no consensus as to which ones should be used routinely. As soon as there is, Clement Clarke will update these web pages.

My patients keep a peak flow diary, and have been given a new meter - do they have to start again?

Not necessarily. As long as they identify which PEF readings came from which meter, then you can convert from the "old" scale into the "new" by using our on-screen converter.

What should I tell patients who will be getting a replacement PEF meter?

Those patient who have used a peak flow meter before will need to know that the way peak flow is measured has been improved, and their PEF readings may have changed - even though their asthma may not have.

If a patient knows what their normal reading is when they are well (e.g. their personal best), then advise them what reading they could expect on a new EU scale meter by converting the Wright reading.

Do I need to replace the old-scale meters immediately?

No. The Mini-Wright is one of the most reliable medical instruments available, but meters that are older than three years, or ones that have been damaged in any way should be replaced with a new "EU" scale Mini-Wright as soon as possible - to ensure lung function is monitored accurately. The MHRA has advised that patients should have their existing Wright scale meter replaced before September 1st, 2005. The opportunity to replace a PEF meter should be taken the next time a patient attends for a review.

Healthcare practitioners who have their own PEF meter should obtain a new EU scale meter to facilitate PEF measurement using either meter. The new EU scale Mini-Wrights will be available from major equipment suppliers, directly from Clement Clarke, and also from NHS Logistics (code FDD 609 Standard Range meter).

Our office / clinic has many peak flow meters - should we replace them all at once?

Depending on when your own country introduces the new EU scale meters, it would be sensible for all professionals working together to start using the new scale PEF readings from the same date.

Disposing of all Wright scale meters and replacing them with new EU scale meters will help standardise all readings taken by healthcare professionals, and it is likely that quantity discounts can be negotiated from suppliers (contact Clement Clarke for details).

I prefer using low range meters with those with severe airflow limitations - are they covered by the "EN 23747" Standard?

The new EU Scale Mini-Wright Low Range will conform to the EN 23747 Standard for the 30 to 400 l/min range that it covers

The authors of the new standard for peak flow meters believed that if the "standard range" peak flow meter could be made more accurate, there would be no need for a "low range" meter. Therefore, unfortunately, any "low range" peak flow meter is technically unable to meet every test in the standard - in the case of Mini-Wright Low Range, the only test that the meter would fail is its ability to measure right up to 800 L/min !

As the Mini-Wright Low Range meter only measures between 30 and 400 l/min, this meter cannot officially be marked as "EN 23747 compliant", but it will display the "EU" symbol to help with recognition.

A concession by the U.K. Government's authorities will ensure that health professionals can still prescribe a low range meter for children, the elderly and those with severe asthma. The situation in other countries in Europe remains unclear, but Clement Clarke will make the Low Range Mini-Wright meter available to all who request it.

Will Wright scale meters be reimbursed by the NHS after September 1st 2004?

No the PPA rejected the request for a period of time when both meters could be reimbursed.

Will EU scale meters be reimbursed before September 1st 2004?


Will Wholesalers and Manufacturers accept return stock after September 1st 2004?

Not without prior agreement. To avoid being left with peak flow meters that cannot be reimbursed, stock should be monitored closely. It is advisable to check for availability of Wright-scale meters during the weeks before the September 1st changeover date. Clement Clarke is committed to making stock available for you and your patients.

When will the new meters be available from Wholesalers?

The new meters will be available from wholesalers from the end of July 2004. See above for PIP codes and part numbers.

What other information is available?

Clement Clarke will be providing additional resources to health professionals over the next few months - this website will carry additional information when available.

Pharmacist Information.pdf Filesize : 110 Kb
You will require Adobe Reader to view pdf files - download it here
obtaining a mini wright | contact | site map | news and events

© 2021 Clement Clarke International